This starts the line at the construction plane origin.Īt the End of line… prompt, type 12,6,10 and press Enter Start the Line command and place the first line point at 0,0. Spherical (radius With w prefix you can type world coordinates, with r prefix relative coordinates, and with wr prefix world relative coordinates.Ģ,-11 (2,-11,0) When you omit the z coordinate, it is automatically set to 0. You can type x and y coordinates or x, y and z coordinates to place points. When prompted for a point, you can click the mouse in a viewport to define the point coordinates or you can or type the coordinates in several ways: The “°” symbol can be used, but it is easier to just type d.Ĥ5 (If no units are specified, then degrees are assumed.)ģ.1415926535897932384626433832795r (pi radians) Positive angular measurement is counterclockwise. The direction for 0 degrees is 3 o’clock. Use any of the Rhino angle unit measurements including fractions. You can mix fractional and decimal input. Use any of the Rhino unit measurements including fractions. For example, if your model units are meters and you type 27cm, Rhino automatically converts your number to 0.27. Rhino will automatically convert the number you type into the model’s units. Note: You can specify units when typing lengths and point coordinates. Note: No spaces are permitted in a number, angle, or coordinate point. There are many ways to enter points, numbers, and angles in Rhino. Using numbers in Rhino for distance, angle, and coordinate entry.